Wednesday, October 16, 2013

Steps to Take in Air Condition Gas Leak Problem


An air-condition gas leaking problem is extremely difficult and costly to solve.

An initial step to identify gas leak is by checking the gas pressure level with a pressure meter. If the pressure meter shows zero, that is the sign of gas leak because the compressor can never be emptied.

The air-condition technician will then pump in the freon, either R22 to 68PSI or R410a to 135PSI to the air-conditioner, this depend on what refrigerant your air-conditioner takes in. You can check what refrigerant your air-conditioner takes in by looking at the label beside the fan coil unit.

From there, the technician will monitor the gas level. If the pressure drops within a few days, weeks or even months, this is a confirmation sign of gas leak because if the gas is top-up fully, it will last at least for a year. The rate of leaking is also dependent on the size of the crack.

So where is the leak source usually from?

The leak can be at the fan coil, inside the condenser or the copper pipes. The cracks are usually found at the joint soldering portion and copper pipes near the compressor. The crack occurs when two copper pipes touch each other and due to the vibration of the running compressor, the copper pipes will crack and gas leak occurs.

There are few methods and equipment used for identify leak source.

1. Hand-Held Refrigerant Leak Detector which detects a leak. A beep sound will be heard when it touches the copper pipe.

2. Ultraviolet (UV) Dye which detects a leak by inserting a coloured dye into the copper pipe and the colour will show where the leak is.

3. Soap and Water. Bubbles will form when the soap and water is placed on the leak site.

Once the leak is found, here are the methods to seal of leaks:

1. Compression Tape is used. The tape will seal the leak source when the tape is placed over the leak area.

2. Soldering. Soldering is a process in which two or more metal items are joined together by melting and filling the leak area with a filler metal.

In the methods and equipment mention above, fixing the leak may sound simple. But in fact, gas leaks are extremely hard to detect and seal. Especially if the leak source is in the copper pipes, it is almost impossible to detect the leak as it is concealed inside the wall, and it is very hard to perform soldering to seal up the leak source.

No comments:

Post a Comment